Summarized tests
Line impedance
-Disconnect all nodes
-Remove termination R
on near end
OK Start test
The test instructions are to be understood as follows: the termination resistor
must be removed from the line end to which the CANcheck is connected. The
other line end should be terminated.
The line impedance can only be correctly measured if you have connected the
CANcheck where normally one of the two termination resistors of the CAN net-
work is located.
In the case of correct line impedance, the message "TEST PASSED" and the virtual
keys "END" and "INFO" appear in the display at the end of the test.
Line impedance
TEST PASSED
END INFO
End the tests of the line parameters with the virtual key "END". You can now look
at all test results under "Stored results".
Copyright IXXAT Automation GmbH
CANcheck Manual, Version 1.2
17
