Operation Manual – ITW GSE 6400 Tier 4
2) To change the lubricity filter:
a) Place a pan underneath the fuel filter to catch spilled fuel.
b) Shut off fuel valve.
c) Drain off some fuel by opening the drain valve.
d) Undo fuel filter with commercial tool and spin off.
e) Clean any dirt from the filter carrier rim
f) Apply a light film of oil or diesel on the rubber seal on the new filter.
g) Fill new filter with diesel fuel.
h) Screw in the new fuel filter “snug”.
i)
Check that the cartridge is seated correctly against the gasket and tighten with a final
half turn.
j)
Make sure that all rags, or absorbent sheets, are clear of moving engine parts and
cannot be drawn in to the radiator fan.
k) Open fuel valve.
l)
Start the engine and check for leaks. Correct as necessary with the engine off.
c) Primary Fuel Filter
A primary fuel filter is mounted above the engine starter in the engine compartment. The filter’s
function is to remove foreign material from the fuel before it enters the fuel lift pump.
CAUTION
When installing new element, do not over tighten it; mechanical tools may distort or
crack filter head.
Replacement fuel filter
part number:
Fleetguard: FF90567
Change the fuel filter after
every 500 hours of
operation.
Figure 2-2-6: Primary Fuel Filter
OM2248 Rev B
Page 74 of 104
Содержание 6400 Tier 4
Страница 49: ...Operation Manual ITW GSE 6400 Tier 4 c Black Box OM2248 Rev B Page 48 of 104 ...
Страница 53: ...Operation Manual ITW GSE 6400 Tier 4 OM2248 Rev B Page 52 of 104 ...
Страница 96: ...Operation Manual ITW GSE 6400 Tier 4 This page is intentionally left blank OM2248 Rev B Page 95 of 104 ...
Страница 104: ...OM2248 Rev B Page 103 of 104 ...
