£n
isel
Ê«>VÌʵիiÌÊ*
x°{
ÀÃÌÊVÃÃ}
During the first commissioning, you should carry out the following steps:
- For the first opening of the hood, connect the power cable and turn on the mains switch.
The COVER button
➅
should light up now; you can open the hood if this button is lit.
- Emergency-Off must be released for all following functions.
- Close the hood and turn on the power stage using the POWER push-button
➁
;
the push-button must light up.
- You can execute the software at any time. However, an error message is displayed if the
machine is not operational (power stage turned on).
- You can start a program stored on FLASH-EPROM by pressing the START button.
Of course, the machine must first be set up correspondingly.
- The hood is locked while tooling. You can only open the hood after the machine stands
still, the tooling machine is off, and the software enables the opening of the hood
(the COVER button lights up).
- You must press the COVER button for opening the hood. The hood is automatically locked
after closing. To start the machine, you must press the START button again.
Please, refer to the corresponding software manual for all further information on working
with the software.
Keyswitch
For debugging the program, you can nevertheless open the hood during the operation if
you turn the keyswitch to TEST (test operation). In this case, the tooling machine must be
switched off but the work program is continued.
Take care to retract the tool from the work piece!
/
ÃÊiÞÊ>ÞÊÞÊLiÊÕÃi`ÊLÞÊiÝ«iÀÌÊ>`Ê>ÕÌ
Àâi`Ê«iÀÃiÊÃViÊÊ«ÀÌiVÌ
>}>ÃÌÊÛ}Ê>V
iÊ«>ÀÌÃÊÃÊ>Û>>LiÊ>ÞÀiÊ>vÌiÀÊ«i}ÊÌ
iÊ
`°
Tooling machine
(only in the case of type 3)
The tooling machine is directly wired and switchable using the software.
The same applies to the three other switchable outputs (optional) that you can use to switch
optional devices (refer to the technical data).
The tooling machine can only be turned on if the POWER button is lit, the hood is locked
close, the rotary switch at the machine is set to ON, and the software controls the machine.
