Isel ICP 2015, Инструкция по эксплуатации и обслуживанию

Страница: 16 / 28

£È
isel
‡ ʜ“«>VÌʵՈ«“i˜ÌÊ*
1 6 2 3 4 5
x°Ó “«œÀÌ>˜Ìʜ«iÀ>̈˜}ʈ˜vœÀ“>̈œ˜
Push-buttons and switches
The black “>ˆ˜ÃÊÃ܈ÌV is located on the rear side of the machine directly beside the mains
connection.
Using the switches and/or push-buttons on the front side, you can switch the machine on and
off and start and stop the processing in a purposeful manner.
➀
“iÀ}i˜Vއœvv
Abort of all functions; the error status remains
testable using the software; after a delay,
the hood can be opened using the
➅
push-
button. Releasing Emergency-Off by turning to
the right.
➁
*"7,
You can only turn on the power stage if Emergency-Off is released.
➂
iÞÃ܈ÌV
Using the key, you can switch between test and automatic operation.
AUTO = processing mode
In the automatic mode, the machine either works stand-alone based on the
program that is stored in the FLASH EPROM (CNC mode) or via the connected
supervisory computer (DNC mode). You can interrupt tooling using STOP and
continue to work using START.
TEST = test mode
In this operating mode, you can open the hood at any time if the tooling machine
is switched off. You can continue to process the programs. However, the tooling
machine is switched off if the hood is opened and can not be switched on again.
The sledge remains freely moveable also with manual traversing (teaching).
/>ŽiÊV>ÀiʜvÊÌ iʓœLˆiÊÏi`}i\ÊÊ>˜}iÀʜvÊLÀՈȘ}t
*>ÞÊ>ÌÌi˜Ìˆœ˜Ê̜ÊÌ iʓœÛˆ˜}‡ˆ˜Ê`i«Ì \ÊʜˆÃˆœ˜Ê`>˜}iÀÊÜˆÌ ÊÌ iÊܜÀŽÊ«ˆiVit
➃
-/,/
- If a program is stored on the FLASH EPROM then the program is started by pressing
this button independently of whether a computer is connected or not.
- After a hold using the button
➄
, the machine restarts the stopped movement
exactly at the location where it was interrupted provided that tooling has not being
terminated via the man-machine interface.