Isel ICP 2015, Инструкция по эксплуатации и обслуживанию

Страница: 11 / 28

££
isel-
ʜ“«>VÌʵՈ«“i˜ÌÊÊ*
S
S
S
In order to lubricate the Y-axis, you must
completely push* the T-slot plate to the
front. Next, unscrew (six screws) it from the
Y-axis.
Remove the plastic plug lying under it and
lubricate through the now visible lubricating
nipple.
You reach the shaft guides through the
sealing lips.
Loosen the all around holding-down screws
in order to remove the cover sheet of the Y-
axis.
in all drawings is the characterize accesses
to the greasing points.
To lubricate the X-axis, move the
sledge to the left*. Remove the
plastic plug on the left side of the
machine and lubricate through the
now visible lubricating nipple.
You access the shaft guides again
through the sealing lips.
At the Z-axis, you must first take the tooling machine
from its support. Remove the three plugs and push the
sledge completely down*. You can apply some oil
onto the shaft guides through the two side holes.
The lubricating nipple for the drive is now behind the
front opening.
IÊ9œÕÊV>˜Ê`ˆÃ«>ViÊÌ iÊÏi`}iÊÕȘ}ÊÌ iÊ >˜`ʈvÊÌ i
“>V ˆ˜iʈÃʜvv°