Isel ICP 2015, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 28

£Ó
isel
‡ ʜ“«>VÌʵՈ«“i˜ÌÊ*
/ iÊvÕÀÌ iÀÊ`iÃVÀˆ«Ìˆœ˜ÃʜvÊV >«ÌiÀÃÊxÊ>˜`ÊÈʜ˜ÞÊ>««ÞÊ̜ʓ>V ˆ˜iÊÌÞ«iÃÊÓÊ>˜`Êΰ
x œ““ˆÃȜ˜ˆ˜}
x°£ *Ài«>À>̈œ˜Ã
For controlling the CNC machine and/or the FLASH EPROMs, you require one
IBM compatible computer with a free serial interface.
System request - 486 SX, 40 MHz and higher
- 8 MB RAM
- 20 MB of free hard disk capacity
- VGA card
- MS-DOS 5.0 and higher
Connecting cables
The serial port is used as an interface of the machine to the computer using the enclosed
cable (max. three meters in length, you find the pin assignment of the 9-pin Sub D
connector in the Specification section).
Connect the red
connector of this cable to
the PC. This side of the
cable is again marked
with <<PC/AT<<.
Connect the gray coupler
on the reverse side of the
ICP.
Use the multiple socket
strip for connecting
power to the computer
and to the machine.
Connect the power cable
only if the machine is
ready for commissioning.
Mount the >݈ÃʜvÊÀœÌ>̈œ˜ (optional) onto the T-slot plate in accordance with the assembly
and operating instructions of the axis of rotation in the appendix. Connect the cable to the
axis of rotation and the female Sub D-9 connector in the rear wall of the working space.
How to precisely set up the axis of rotation is also described in the assembly and operating
instructions in the appendix.