£Ç
isel-
Ê«>VÌʵիiÌÊÊ*
➄
-/"*
Execution of the current program is immediately stopped and remains at the (program)
location. The tooling machine is switched off. In the DNC mode, you can issue further
commands via software. This is not possible in the CNC mode.
After a time delay of 1 or 5 seconds, the COVER button lights up and you can open the
hood. With a closed hood, you can continue the program by pressing the START
button.
➅
"6,
Only if the button is lit, you can open the hood by pressing this button (first, press the
button, then pull simultaneously at the grip!). In the unfavorable case if you set only a
delay period of one second, the spindle can continue to rotate for a few seconds.
ÊÌÊÀi>V ÊÌÊÌ iÊÃÌÊÀiÛÛ}ÊÌ°
x°Î
/ iÊ-Ê*,"
(use only for free programming)
You can permanently store a processing program for the machine on the FLASH EPROM.
You can erase it again and store a new program. The machine can thus be started
independently of the controller and process a work piece (CNC mode).
This operating feature is especially suitable for small series productions.
You must erase the FLASH EPROM before you can write to it again.
Erasing the FLASH EPROM:
1. Turn on the mains switch (Emergency-Off released, POWER not pressed)
2. Activate the TEST mode
3. Keep the STOP button pressed and press the POWER button once shortly
Please, read the corresponding manual for the coding of programs and saving these onto
FLASH EPROM (programmer’s guide of the IMC4 2.xx).
