n
isel
Ê«>VÌʵիiÌÊ*
Î
-iÌÊÕ«Ê>`ÊViVÌ}
The machine is provided completely mounted on a palette.
Contained in
ÃV«iÊvÊ`iÛiÀÞ
of the ICP are:
• machine case with three linear axes included
- complete controller electronics (only type 2 and 3)
- drilling and milling machine with 3 mm split chuck - as a standard (only type 3)
• key for split chuck, SW 22 (only type 3)
• clamping set (hand lever, stop bars, 5 mm socket spanner)
• triangular wrench for unlocking the hood switch
• AC power cable, PC - machine data cable (only type2 and 3)
• 4-fold socket outlet with illuminated mains switch (only type 2 and 3)
• Driver software for DOS including setup program, 1 floppy disk, 1 manual (type 2 and 3)
• PRO-PAL program, 1 floppy disk, + processing example (only type 2)
• REMOTE program, 1 floppy disk, + processing example (only type 3)
• ISY-CAM CAD/CAM software (only type 3)
• and these service and maintenance instructions
The
ë>ViÊÀiµÕÀiiÌ
of the machine is limited to the external measurements and to
sufficient room in front of the machine in order to operate and arrange the processing, plus
approx. 10 cm behind the machine to allow for connectors. The hood of the housing opens
upwards. Thus, the required total height is approx. 1,2 meters.
ÊÊÊÊÊÊÊÊÊÊÊÊÊÊÊÊÊÊÊiÃÃÊ>`Êë>ViÊÀiµÕÀiiÌ
Remove the sheet steels of the feet of the machine with which it is secured on the palette.
Then, set up the machine horizontally onto a flat, fixed face.
You can compensate for small unevenness of the base area at the feet.
