IP-COM G3210P, Руководство пользователя

Страница: 95 / 138

90

Advanced Settings
4.5 Enable Trap
Trap function is used to inform the SNMP manager of critical events for the switch. Click
Device Management > SNMP > Enable Trap to enter page below:
By default, the SNMP Trap function is enabled on all ports. You can modify it as you need.
Parameters on this page are described below:
Field Description
SNMP Trap Enable/ Disable SNMP Trap function.
State Select the Trap message type.
Coldstart-Trap
Send Coldstart Trap to designated host when device is
undergoing a coldstart (power disconnection or reboot).
Warmstart-Trap
Send Warmstart Trap to designated host when the SNMP is
disabled on the switch.
Linkdown-Trap
Send Linkdown Trap to designated host when an up link
becomes down.
Linkup-Trap
Send Linkup Trap to designated host when a down link
becomes up.
Authentication-Trap
Send Authentication failure Trap to designated host when
SNMP module encounters an authentication failure.
This page is only for enabling the SNMP Trap function. See the following for configuring
the Trap Host to which Traps are to be sent.
4.6 Trap Setup
To enter the page for configuring the host to which Traps are to be sent, click Device
Management > SNMP > Trap Setup as seen below.