SEPAMAT F-SC_Manual_Vers.1.0e_en
4
2. Safety instructions
The live components have to be installed only by a qualified electrician. In
case of failure of the electronic device, the product has to be repaired by a
qualified electrician before being operated again. There is a risk of electric
shock!
The outlet circuit used for the device has to be secured through a protected
circuit breaker (16 A in most countries). If unavailable, an FI switch with
maximum operating current of 30 mA has to be connected.
These installation and operating guidelines have to be read carefully before
installing the product. The instructions mentioned have to be strictly followed.
Modifications to the product are not permitted, otherwise the warranty
becomes void.
The following points have to be strictly observed during installation and operation:
•
Check the product before installation for any visible defects. If defects are present, then the
product must not be installed. Damaged products can be dangerous.
•
Installations at the mains water pipeline system can only be performed by a qualified
installation company.
•
A floor drain has to be provided near the installation site, which can collect inadvertent water
discharges (i.e. pump defects, pipe breakages, etc.) and prevent water damage inside the
building.
•
The mason work behind the water-handling unit must be protected from water damage (i.e.
with water-resistant coating).
•
Make sure that the existing emergency overflows are connected and adequately sized.
•
Remove the mains electrical plug if you will be away for more than 24 hours.
•
Close the mains water line at the inlet of the device if you will be away for more than 24
hours.
•
All products must be regularly inspected to maintain proper condition. The minimum
inspection interval is mentioned in the maintenance section.
•
Electrical devices may be hazardous for children. Therefore children always have to be kept
away from the product. Do not let children play with the product.
•
Do not install the water-handling units in locations where the temperature may drop below
0°C.
•
Do not install any electrical products in flood-prone areas.
•
The operator is responsible for adherence to the safety and installation guidelines.
