SEPAMAT F-SC_Manual_Vers.1.0e_en
12
5.1.2 Cable connection plan
In the event of a damaged cable or faulty pressure sensor, it is necessary to open the housing of
the pump control. To do this, the mains plug must be disconnected and you have to wait for at least
2 minutes until all LEDs turn off (internal capacitors are discharged). You may open the case only
after this. To do this, you have to demount the complete pump control from the angle holders. Then
the rear screws of the heatsink can be opened.
Mains input connector (230 V / 50
Hz)
Pump connector (3 ~230V÷400 V)
Pressure sensor (4-20 mA output)
S (white cable)
+15 V (brown cable)
