Intermec Sabre 1555 RFID, Руководство по обслуживанию

Страница: 36 / 65

Sabre 1555 RFID and Bar Code Reader Service Manual
2-22
4. Turn the assembly right side up and tilt the digital board up as shown in the next
illustration, and remove the two Phillips screws on the underside of the chassis
assembly to remove the scan engine.
Phillips screws
for scan engine
2.4 GHz 915 MHz
5. Place the new scan engine in the chassis assembly. Make sure the scan engine
connector faces away from the shield or antenna.
Scan engine
connector
2.4 GHz version
915 MHz version
6. Install the two Phillips screws to hold the scan engine in place. Torque to .339 Nm
(3.0 lb-in).
7. Position the digital board in place on top of the RF board assembly. From the
bottom of the RF board assembly, install the two Torx screws to hold the assembly
onto the RF board. Torque to 0.339 Nm (3.0 lb-in).
8. Make sure the 8-pin connector on the back of the scan engine and the 12-pin
connector on the digital board are unlatched.