Intermec Sabre 1555 RFID, Руководство по обслуживанию

Страница: 29 / 65

Replacing Parts in the 1555
2-15
2
Removing and Replacing the Digital Board
To replace the digital board you need:
•
Digital board (P/N A060012-01 (2.4 GHz), or A060012-02 (915 MHz))
You need this tool:
•
Torque driver with a #10 Torx bit
To remove the digital board
1. Open the 1555 and disconnect the upper case assembly as described on page 2-12.
2. Disconnect the 8-pin flex cable from its connector on the rear of the scan engine.
3. Disconnect the 12-pin flex cable from its connector on the digital board.
8-pin flex cable
12-pin flex cable
4. Remove the Torx screw holding the digital board on the RF board assembly.
2.4 GHz
shown here