Intermec EasyCoder PF2i, Руководство пользователя

Страница: 61 / 194

Chapter 2 — Connecting the Printer
PF2i and PF4i Mid-Range Printer User’s Manual 47
2 Send the following commands to permanently assign the IP
address, subnet mask, default router, and name server:
<SI>n n [ ,m1 [ ,m2 ]]
where:
n is the IP address of the printer in the format n.n.n.n, where n is a
number from 0 to 255.
,m1 is the subnet mask address in the format n.n.n.n, where n is a
number from 0 to 255.
,m2 is the router address in the format n.n.n.n, where n is a
number from 0 to 255.
3 Disconnect the printer from the PC.
4 On your PC, enter the IP address of the printer in the address field
of your web browser (for example http://10.200.27.94) and press
Enter .
The home page of the printer appears.
Setting Up 802.11 Radio Communications
If your printer has an optional 802.11 b/g radio, you can transfer and
receive data using wireless communications. This manual assumes
that you have already set up your wireless communications network
including your access points. This section describes how to set up
wireless security on your printer.
The printer supports these authentication modes:
• none
• WEP (64 bit and 128 bit)
• WPA Personal and Enterprise mode (802.1x authentication)
• WPA2 Personal and Enterprise mode (802.1x authentication)
Note: You must specify at least two of the three parameters for the
command to take effect.
Note: WPA and WPA2 Enterprise mode currently support PEAP,
TTLS, LEAP, and EAP-FAST. For LEAP authentication, the printer
supports Open EAP, but does not support Network EAP.