Intermec EasyCoder PF2i, Руководство пользователя

Страница: 123 / 194

Chapter 4 — Troubleshooting and Maintaining the Printer
PF2i and PF4i Mid-Range Printer User’s Manual 109
3 Lift and lower the printhead.
4 Press the Print button.
5 Make sure there is a label (not a gap or mark) at the LSS.
6 Make sure that the media is routed as close to the center section as
the guide allows.
7 Press
T
to enter the Setup menu, and use the keypad to go to the
LSS menu:
• If you are running Fingerprint, go to SETUP > PRINT DEFS >
LSS TEST > LSS AUTO .
• If you are running IPL, go to SETUP > TEST/SERVICE > LSS
TEST > LSS AUTO .
The screen displays the LSS AUTO menu with the cursor in the
center.
8 Check gap detection:
a Lift the printhead.
b Slowly pull out the media. When the LSS detects a gap or
detection slot, the cursor moves to the right.
LSS AUTO
Note: There is no way to adjust the LSS function; the menus
only indicate values obtained from the LSS. The test menu can
determine if the sensor unit is not physically in position, is blocked
by dust or stuck labels, or is defective in some way.
LSS AUTO