SECTION 2
"
Installation Instructions
RT5900 SERIES Mobile Mount Radio Data Terminal
2-3
Introduction
The Mobile Mount Radio Data Terminal can be mounted on motorized
load-handling equipment such as a forklift. During this installation the
power cable is wired directly to the vehicle battery or bank of batteries.
This direct connection takes advantage of the filtering and regulation capa-
bilities of storage batteries.
The case and the power input of the terminal are electrically isolated from
each other. This means it does not make any difference if the vehicle has a
positive or negative ground electrical system. It is important to make sure
that you connect all wiring exactly as instructed in this manual.
A power supply-converter built into the Mobile Mount Radio Data Terminal
accepts a wide range (12--56 volts d.c.) of input voltages (see
Specifica-
tions
).
If the overall vehicle voltage exceeds 56 volts,
you should tap into
the bank of batteries at a point that is 56 volts or less.
Since each situation or equipment type may pose unique requirements,
mounting hardware selection and mechanical installation of the Mobile
Mount Radio Data Terminal shall be the responsibility of the installer. We
recommend using 3/8-inch nuts and bolts, with flat and lock washers to
install the mounting bracket.
This kit contains nuts, bolts, washers, and two (3/8- inch) terminal rings for
connecting the electrical cable
directly
to the vehicle battery. A waterproof
in-line fuse holder must be installed between the positive battery terminal
and the red wire in the power cable.
