To define the DDNS parameters:
1. From the menu toolbar, click
Configuration
>
Network
>
DDNS
.
2. Select
Enable DDNS
to enable this feature.
3. Select
DDNS Type
. Two options are available: DynDNS and IPServer.
• Select
DDNS Type
. Select one of the following options:
•
DynDNS:
Enter the DDNS server address, members.ddns.org, which is used to
notify DDNS about changes to your IP address, the host name for your camera,
the port number (443 (HTTPS)), and your user name and password used to log
into your DynDNS account. The domain name displayed under “Host Name” is
that which you created on the DynDNS web site.
•
ezDDNS:
Enter the required host name under “Host Name”. The default host
name is utc-serial number. The new host name is registered when you click
Save.
Note:
The default server address is www.tvr-ddns.net, which cannot be changed.
4. Click
Save
to save changes.
To define the PPPoE parameters:
1. From the menu toolbar, click
Configuration
>
Network
>
PPPoE
.
2. Select
Enable PPPoE
to enable this feature.
3. Enter User Name, Password, and Confirm password
for PPPoE access.
4. Click
Save
to save changes.
To define the SNMP parameters:
1. From the menu toolbar, click
Configuration
>
Network
>
SNMP
.
2. Select the corresponding version of SNMP: v1, v2c or v3.
3. Configure the SNMP settings. The configuration of the SNMP software should be
the same as the settings you configure here.
4. Click
Save
to save changes.
Note:
Before configuring SNMP, test your SNMP monitoring software and attempt to
receive the camera information via the SNMP port. By setting the Trap Address, the
camera can send the alarm event and exception messages to the SNMP monitoring
software. The SNMP version you select should be the same as that supported by the
SNMP software.
To define the 802.1x parameters:
1. From the menu toolbar, click
Configuration
>
Network
>
802.1X
.
2. Select
Enable IEEE 802.1X
to enable the feature.
3. Configure the 802.1X settings, including EAPOL version, user name, and password.
The EAPOL version must be identical with that of the router or the switch.
4. Click
Save
to save changes.
TruVision Stainless Steel IP Cameras Configuration Manual
15
