Intergraph StudioZ RenderRAX III, Настройка системы

Страница: 83 / 94

73
Do the following after installation of the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM. Alternatively, you can install the drivers or other system
software from the Windows NT CD-ROM if you do not have them on diskette.
u
If your system has a QLogic Fibre Channel host bus adapter, run
SETUP
.
EXE
from the
backup diskette to install the driver. See the
README
.
TXT
file on the backup diskette for
more information.
NOTE Do not install InterSite Hardware Monitor, ECC Memory Monitor, Watchdog, or SMART Disk
Driver on RenderRAX III systems. These products interrupt video streaming (causing dropped
video frames) and consume rendering resources.
u
Perform any additional installation and configuration tasks described in the Late-Breaking
News document delivered with your system.
u
Configure the system as described in Chapter 3, “Configuring the System.”
u
If your system was running Windows NT 4.0 Service Pack software, install this software
after installing drivers and other system software, and after installing any application
software products.
u
Perform any operational changes required for your system as described in Chapter 4,
“Operating Notes.”
Do the following after you install Windows NT Service Pack software:
u
If you created a Quick-Fix Engineering (QFE) backup diskette from Version Manager
during any previous initial system configuration, install the QFE update software. See the
README
.
TXT
file on the QFE diskette for more information.
u
Complete the additional installation and configuration tasks in this section.
Enabling Bus Mastering for IDE/ATAPI Devices
Your system shipped with bus mastering for IDE/ATAPI devices enabled. If you reinstall
Windows NT 4.0 and the latest Service Pack software certified by Intergraph Computer
Systems, you should enable IDE/ATAPI bus mastering.
NOTE If you have a CD-Recorder drive installed, do not enable IDE/ATAPI bus mastering. The CD-
Recorder drive is incompatible with IDE/ATAPI bus mastering.
To enable IDE/ATAPI bus mastering:
1. Ensure that the operating system, the latest certified Service Pack software, and the QFE
update software (
QFE
_
NTW
) are installed.
NOTE The QFE update software includes an updated ATAPI device driver that should be installed
after the Service Pack software.