Intergraph StudioZ RenderRAX III, Настройка системы

Страница: 73 / 94

63
System Boot
Does not boot from the expected boot device:
Reason Solution
Operating system not on the system drive. Install the operating system as described in
Chapter 7.
IDE hard disk drive is connected to IDE
controller. BIOS cannot boot from a SCSI hard disk
drive if IDE hard disk drive is connected.
Disconnect all IDE hard disk drives. For
more information, see the System Reference.
Incorrect BIOS setting for boot drive (non-
RAID system). BIOS Multiboot/Hard Drive option must be
set to SCSI ID 0. See Chapter 5.
System with internal SCSI disks attempts to
boot from CD-ROM drive instead of a SCSI
disk drive. Do not boot the system with a bootable CD-
ROM disc (such as the Windows NT
software CD-ROM) in the CD-ROM drive.
You may want to change the system’s boot
device order in the BIOS to boot from a
SCSI disk drive before booting from the
ATAPI CD-ROM drive. See Chapter 5.
Series of beeps and error messages display:
Message Explanation and Solution
Refresh Failure Bad memory refresh circuitry on the system
board. Remove and reinstall DIMM(s). If
error persists, replace the DIMM(s).
Parity Error Parity error in the first 64 KB block of
memory. Remove and reinstall DIMM(s).
If error persists, replace DIMM(s).
Base 64 KB Memory Error Memory failure in the first 64 KB. Remove
and reinstall the DIMM(s). If error persists,
replace the DIMM(s).
Timer Not Operational Memory failure in the first 64 KB, or Timer
1 on the system board is not functioning.
Call the Customer Response Center.
Processor Error The CPU on the system board generated an
error. Call the Customer Response Center.
8042 - Gate A20 Failure The BIOS cannot switch to protected mode.
Call the Customer Response Center.
Processor Exception Interrupt The CPU generated an exception interrupt.