Intergraph StudioZ RenderRAX III, Настройка системы

Страница: 69 / 94

59
Parallel Port Mode
This option specifies the parallel port mode. The Optimal default setting is Normal. The
settings are:
Setting Description
Normal The normal parallel port mode is used.
Bi-Dir The parallel port can be used to data transfer in two directions.
EPP The parallel port can be used with devices that adhere to the Enhanced Parallel
Port (EPP) specification. EPP uses the existing parallel port signals to provide
asymmetric bi-directional data transfer driven by the host device.
ECP The parallel port can be used with devices that adhere to the Extended Capabilities
Port (ECP) specification. ECP uses the DMA protocol to achieve data transfer
rates up to 2.5 Megabits per second. ECP provides symmetric bi-directional
communication.
EPP Version
−
The Optimal default setting is N/A.
Parallel Port IRQ
The settings are 5 and 7. The Optimal default setting is 7.
Parallel Port DMA Channel
The Optimal default setting is N/A.
Onboard IDE
This option specifies the IDE channel used by the on-board IDE controller. The settings are
Disabled, Primary, Secondary, and Both. The Optimal and Fail-Safe default setting is Both.
Auto-Detect Hard Disks
This option detects hard disk drives attached to each IDE channel and sets their parameters
automatically.
Change Supervisor Password
This option lets the user set a password which limits changes to specific BIOS parameters to
those made by the Supervisor.