Intergraph StudioZ RenderRAX III, Настройка системы

Страница: 21 / 94

11
7. Connect the system power cord to the AC receptacle on the base unit.
8. If using an AC distribution box or UPS, connect its power cord to a grounded, three-
prong AC power outlet.
CAUTION Ensure the circuit breaker on the AC distribution box is set to Off before connecting the power
cord.
NOTE The UPS starts automatically when its power cord is connected to the power outlet. Refer to
the UPS documentation for more details.
9. Connect the power cords from the monitor, system, and any external optional peripherals
to receptacles on a grounded, three-prong AC wall outlet, an AC distribution box, or an
uninterruptible power supply (UPS).
10. If you have any disk drives to install in the disk drive bay, refer to “Installing Disk Drives
in the Disk Drive Bay” later in this chapter.
Installed Expansion Cards
Expansion cards are installed in the Accelerated Graphics Port (AGP), Peripheral Component
Interconnect (PCI), and Industry Standard Architecture (ISA) expansion slots in the base unit.
The layout of expansion slots, and the typical location of some installed standard and optional
cards, are as follows:
Slot Type Expansion Card
Left AGP Graphics adapter
PCI Open
PCI Symbios dual-channel LVDS SCSI adapter
PCI QLogic Fibre Channel host bus adapter (optional)
PCI Mylex RAID controller (optional)
PCI or ISA Network adapter (optional)
Right ISA SoundBlaster 16 audio card
For information on installing additional expansion cards, see the System Reference and the
documentation delivered with the expansion cards.