Intergraph StudioZ RenderRAX III, Настройка системы

Страница: 20 / 94

10
Connect the cable from this To this port Connector
Mouse or mouse cable from
concentrator Mouse port
Keyboard (optional) or keyboard
cable from concentrator Keyboard port
Universal Serial Bus device Universal Serial Bus port
Modem, printer, or other serial
device
1 2
Serial (COM) ports 1 and 2
Printer or other parallel device Parallel (LPT) port
Network Ethernet port on the network
adapter card (optional)
Monitor (optional) or monitor
cable from concentrator Video Out port on the graphics
adapter card
To connect the cables:
1. If you are using a monitor with the system, connect the video cable from the monitor (or
the equivalent cable from a concentrator) to the video out port on the video card in the
expansion slots.
2. Connect the cables for the mouse and keyboard (or the equivalent cables from a
concentrator) to their ports on the I/O panel.
3. Connect other cables to other ports as needed for such devices as printers (parallel port)
and modems or UPS communications (serial ports).
4. Connect any external SCSI devices to the appropriate port on the SCSI adapter card in the
expansion slots. See “Connecting an External SCSI Device” later in this chapter for more
information.
5. Connect cables to ports on other installed expansion cards, such as a RAID controller or a
Fibre Channel host bus adapter, as needed. See “Installed Expansion Cards” later in this
chapter and expansion card documentation for more information.
6. Make sure the voltage selection switch on the back of the base unit is set to the proper
line voltage for your location. If your location uses 115 volts, make sure the number 115
is visible on the switch. If your location uses 230 volts, make sure the number 230 is
visible on the switch.
WARNING If you do not set the voltage selection switch correctly, serious equipment damage may
result when you turn on power to the system.