41
Reset Default IDs
Choosing the Reset Default IDs option from the SCSI ID menu will automatically set the
SCSI IDs to IDs 0, 1, 2, and 4 for the disk drives, and ID 3 for the SAF-TE. SCSI IDs for
the drives will be the same for both SCSI bus channels.
NOTE
ID 3 is normally reserved for the InterRAID-8e SAF-TE board. The SAF-TE board contains
the control and monitoring electronics for the disk array. The SAF-TE board resides in one of
the two slots located in the top bay of the InterRAID-8e cabinet. The SAF-TE board ID uses
“OB” to indicate Off Bus (off line) mode. However, if SAF-TE is off line, the LEDs and other
error reporting signals will not function properly.
Heat Threshold
NOTE
The Heat Threshold value is pre-set at the factory and should not be changed unless directed
by Intergraph Computer Systems Technical Support. The default setting is 116 degrees F
(47 degrees C).
Choose this option to change the temperature value for the temperature monitoring system.
If the temperature exceeds the set value, a Temperature Threshold Exceeded message
displays in the ICP. The RAID cabinet alarm sounds continuously until the problem is
corrected.
SAF-TE Chain ID
This option is for configuring the SAF-TE board for master and slave modes when cabinets
are daisy chained. Intergraph does not recommend daisy chaining InterRAID-8e cabinets.
The default setting for SAF-TE Chain ID is None.
Change Passcode
NOTE
Lock mode is disabled until a passcode is entered. To enable lock mode, enter the default
passcode.
This option allows an administrator to create or change a passcode to protect access to the
SCSI ID menu, Heat Threshold, Change Passcode, and Lock (or Unlock) features.
Use the arrow keys to change the code value (0-9) and the
ENTER
key to move from one field
to the next. Then press the
ENTER
key after you have made your selections. You are
prompted to press the
ESCAPE
key after the passcode is changed for the change to take affect.
The new passcode does not take affect until you have returned to the ICP main menu and
“Status OK” displays.
NOTE
If you lose your passcode, call the Customer Response Center at 1-800-633-7248 and ask
that your call be directed to the Solutions Center.
