Inter-m MEQ-2000, Руководство по эксплуатации, Страница: 40 / 78

MEQ-2000 24/96 Multimode Equalizer
There are four active buttons in CONFIG mode:
F1 – DEF changes settings to factory default.
F4 – DIO opens a submenu for setup of the digital output.
F5 – ENTER confirms the most recently entered changes.
F6 – EXIT returns to the UTILITY menu.
Parameter Window
The CONFIG parameters can be selected using the cursor keys, and changed with
the parameter wheel. The cursor keys have no function in this mode.
After every change, ENTER appears at the F5 key, and must be pressed to confirm the
change.
Note that any configuration change causes the MEQ-2000 to reconfigure the module
chain. Therefore after pressing ENTER to confirm a change, the system will mute all
outputs for a few seconds while reconfiguring.
The available parameters are:
CONFIG provides for selection of module configuration: MA-1, MA-2, RE-1, RE-2,
ME-1, ME-2.
INPUT selects the signal source: ANALOG, DIG XLR, DIG COAX, DIG OPTO. If you
have selected a digital input and a valid digital source is not detected, a
blinking UNLOCKED message will appear in the upper status line and the
input will be muted.
IN MODE defines the input configuration: DUAL CH, MONO CH1, MONO CH2, MONO
CH 1+2.
OUTPUT selects the output mode: ANALOG, DIGITAL, ANA + DIG.
INSERT
provides for input of an external processing device to the unused
input/output pair. The INSERT parameter indicates the point in the
configuration where the external processor is inserted.
Default values are: RE-1, ANA, D-CH, ANA + DIG, OFF .
40