Intel R2000WT, Руководство по системной интеграции и обслуживанию

Страница: 29 / 140

Intel
®
Server System R2000WT Product Family System Integration and Service Guide
13
Install Front Control Panel Assembly and I/O Panel Assembly into 8 x
3.5” Front Drive Bay Module
Figure 11. Front Control Pane and Front I/O Panel Installation into 8x3.5” Drive Bay Module
• Remove the 8 x 3.5” Drive Bay Module from its packaging
•
Insert the Control Panel board into the back of the drive bay module as shown in Figure 9.
Note: Ensure the plastic gasket over the control panel buttons is securely in place before installing the
control panel board into the drive bay module
• The control panel is properly positioned when the buttons are protruding from the Control Panel face
plate on the front of the drive bay module and the screw holes on the top of the assembly are aligned.
•
Using a single screw, secure the Control Panel Assembly to the drive bay module (8 in/lbs torque)
•
Ensure the Control Panel cable is securely attached to the control panel board
•
Carefully feed the Black USB cable and Grey ribbon cable of the I/O Panel Assembly into the I/O Panel
slot on the front of the drive bay module. Cables should come out the back of the drive bay
•
Position the I/O panel assembly into the I/O panel slot
•
Ensure the screw holes on the top of the drive bay module and the I/O panel assembly are aligned
•
Secure the assembly using two fastener screws (8 in/lbs torque)
Control Panel
Assembly
I/O Panel
Assembly