Intel R2000WT, Руководство по системной интеграции и обслуживанию

Страница: 110 / 140

Intel
®
Server System R2000WT Product Family System Integration and Service Guide
94
•
Using 8 fastener screws, secure the drive bay module to the chassis (8 in/lbs torque) (see letter ‘B’)
• Locate the drive bay retention clip
•
Slide the drive bay retention clip over the bottom edge of the drive bay assembly as shown in the
following illustration. The retention clip should clamp together the bottom of the drive bay module to
the chassis base.
•
Re-attach all cables described in steps 5 & 6 of the removal process
• Install storage drives into the same drive bays as where they were removed from
•
Install system fan assembly (see section 2.4.2)
• Install air duct (see section 2.3.2)
7.4 Replacing the Standard Front Control Panel (R2208WTxxx &
R2216WTxxx)
7.4.1 Standard Front Control Panel Removal (R2208WTxxx & R2216WTxxx)
•
Power off the system and remove all power cords
• Remove the system top cover (see section 2.2.1)
•
Remove the air duct (see section 2.3.1)
•
Remove the system fan assembly (see section 2.4.1)
•
From the server board, disconnect the black round front panel USB cable, 14-pin grey front panel video
ribbon cable, and the 30-pin grey front panel ribbon cable
• If a SATA optical drive is installed, disconnect the SATA cable and the peripheral power cable from the
server board
•
Extract the drive bay retention bracket. To extract the drive bay retention bracket, remove the 6 fastener
screws from the top front edge of the drive bay (see Letter ‘A’) and pull out the metal bracket (see letter
‘B’)
•
Remove the 2 fastener screws from the back edge of the drive bay over the I/O Bay Module (see letter ‘C’)