Intel M50FCP1UR, Руководство пользователя

Страница: 91 / 133

Intel® Server System M50FCP1UR System Integration and Service Guide
91
8. If present, remove the OCP add-in card
9. If present, remove all options installed onto the server board, including: TPM Module and M.2 SSDs
10. Remove processors (see Section 6.5 ).
11. Remove all memory modules and DIMM blanks (see Section 6.3 ).
12. Disconnect all cables attached to connectors on the server board.
13. Remove the two metal air baffles attached to the left and right edges of the server board
14. Remove all fasteners used to secure the server board to the chassis (see Letter ‘A’).
15. Slide the server board towards the front of the chassis to disengage all external connectors from the
chassis cut-outs on the chassis back panel.
16. Carefully lift the server board from the chassis and place it into an anti-static bag.
17. Verify that all cables are clear of the board placement target.
18. Locate and carefully remove the server board from its anti-static bag. Hold the server board by its
edges. Do not touch any components on the server board.
Figure 124. Server Board Installation
19. Carefully lower the server board into the chassis.
20. Slide the server board towards the back of the chassis until all external connectors on the back edge
of the server board are in place with the cut outs on the chassis back panel.
21. Verify that all screw holes align with the chassis standoffs (see Letter A).