Instantel 716A0401, Руководство оператора

Страница: 42 / 86

Chapter 3
3–22
MiniMate Plus Operator Manual
that the BlastMate III is displaying the Main Window with the message “Ready to Monitor.” Set
the Serial Connection to Direct and set the baud rate to the same rate in both monitors.
To upload one event, press the Up Arrow key when the Main Window is displayed, until the
Upload One Event Window appears. Press the Enter key to select this choice. The most recently
recorded event appears on the display. Press the Up Arrow to display the next event or the Right
Arrow to display the earliest recorded event. With the required event appearing on the MiniMate
Plus display, press the Enter key to begin the uploading. The message “Uploading” along with
the number of the event appears on the bottom of the MiniMate Plus display. After the event has
been transferred to the BlastMate III, the message “Event Uploaded Successfully” appears
momentarily on the MiniMate Plus display.
3.10.7. Upload All Events
You can copy all the events stored in a MiniMate Plus to a BlastMate III monitor. For example,
you could transfer events from the MiniMate Plus to the BlastMate III then print them using the
BlastMate III printer. MiniMate Plus events printed on a BlastMate III are identified as MiniMate
Plus events on the top of the event summary report.
In order to upload events, you must first connect the MiniMate Plus to the BlastMate III Cable
(716A1801 optional). Plug the BlastMate III end of the cable into the BlastMate III Aux
connector and the MiniMate Plus end of the cable into the MiniMate Plus Aux connector. Check
that the BlastMate III is displaying the Main Window with the message “Ready to Monitor.” Set
the Serial Connection to Direct and set the baud rate to the same rate in both monitors.
To upload all the events, press the Up Arrow key when the Main Window is displayed, until the
Upload All Events Window appears. Press the Enter key to select this choice. The message
“Uploading” along with the number of each event currently being uploaded appears on the bottom
of the MiniMate Plus display. After all the events have been transferred to the BlastMate III, the
message “All Events Uploaded Successfully” appears momentarily on the MiniMate Plus display.
3.10.8. Copy BMIII Notes
This command copies the notes from a BlastMate III to a MiniMate Plus. You require the
MiniMate Plus to the BlastMate III Cable (716A1801 optional).
Plug the BlastMate III end of the cable into the BlastMate III Aux connector and the MiniMate
Plus end of the cable into the MiniMate Plus Aux connector. Check that the BlastMate III is
displaying the Main Window with the message “Ready to Monitor.” Set the Serial Connection to
Direct and set the baud rate to the same rate in both monitors.
To copy the notes, press the Up Arrow key repeatedly on the MiniMate Plus until the Copy
BMIII Notes window appears. Press the Enter key. The message “Copying” appears on the
display followed by “Notes Copied Successfully” when the process completes.
3.11. Cancel Key
Use this key to return to the previous window. It can be pressed at any time during operations.
Pressing the key a number of times always returns you to the Main Window. You can change a
setting and return to the Main Window without scrolling through further windows.
Also, the Cancel key exits all monitoring modes. You may be requested to enter a password
before exiting monitoring. Press the Cancel key. The Password Window appears. You have ten
seconds to enter the four character password. Enter the four character password then press the
Enter key. This password protection can be enabled or disabled by pressing the Option key +
Setups key and choosing the Password command. See page 3–24.