Chapter 3
3–4
MiniMate Plus Operator Manual
Figure 3.4 Installing the Standard
Figure 3.5 Final Installation with
Transducer using the Ground Spikes.
Ground Spikes Pushed Fully into the
Ground.
b. Burying the MiniMate Plus or the Standard Transducer
You can bury the MiniMate Plus or the standard transducer to couple it to the ground and prevent
movement.
WARNING:
Use the standard transducer in wet or poor drainage conditions where standing
water may accumulate. Do not install the MiniMate Plus where these conditions
exist. Standing water may accumulate and damage the monitor. Use the MiniMate
Plus in dry installations where no water is expected.
The ground must be hard and compact with no loose material between the MiniMate Plus or the
standard transducer and the compact ground material. Dig a hole from four inches (10 cm) to six
inches (15 cm) deep. Place the MiniMate Plus in a waterproof plastic bag to protect it from the
surrounding ground material. Position the MiniMate Plus or the standard transducer in the hole
with the arrow pointing toward the event. Level the MiniMate Plus or the standard transducer.
Compact the material around the MiniMate Plus or standard transducer while back filling to
securely couple either to the surrounding ground material. Do not cover the MiniMate Plus face
panel. Press the
Test
key to check your sensors using Sensorcheck.
WARNING:
Seal the plastic bag to ensure water does not accumulate around the monitor.
Содержание 716A0401
