Instantel 716A0401, Руководство оператора

Страница: 10 / 86

viii
MiniMate Plus Operator Manual
•
Always Hold a Cable by its Connector.
Do not hold the cord to pull on a connector when connecting or disconnecting it.
•
Never Force a Connector.
Always align the connector to the port before inserting.
•
Use Only the Instantel Cable Supplied to Connect the MiniMate Plus to a Personal
Computer.
Use the BlastMate
®
III PC connecting cable only, part number 712A2301. Using other cables
including the BlastMate II to MiniMate™ connecting cable, part number 715A0501, may damage
your unit.
•
Never Connect or Disconnect Cables Without First Turning Off the MiniMate Plus
and Your Computer.
•
Do Not Drop the MiniMate Plus or Submerge it in Liquids.
The MiniMate Plus is rugged and designed to withstand normal wear and tear. The MiniMate Plus
is splash resistant designed to withstand temporary exposure to drops of water. It is not waterproof
and should not be immersed in water. Immersing the monitor or installing the monitor where
standing water may accumulate may damage the monitor.
•
Keep Computer Disks Away from the MiniMate Plus and Transducers.
The geophones inside the MiniMate Plus models with an internal transducer and external
transducers contain magnets that could erase the data stored on computer disks.
•
Clean the MiniMate Plus Periodically.
Vacuum dust, dirt, and sand from the MiniMate Plus. Use alcohol to remove stains. Do not use
paint thinners and ketone solvents. These may damage the MiniMate Plus. To avoid scratching the
protective cover and display, do not scrub the surfaces with abrasive material including cleaning
pads.
Condensed Instructions
1.
Connect microphone (if used), secure and level MiniMate Plus™ unit pointing arrow at
blast.
2.
Turn on the unit by pressing * . Watch the display for battery, time and date.
3.
Press SETUP to verify or edit setups. TEST to check geo/mic channels, or
↑
to access
events.
4.
Press START Monitor to enter Monitor Mode.
5.
Depending on setup, the unit does a unit check and displays "Performing Sensorcheck" .
IMPORTANT : Do not touch the MiniMate Plus™ while this message is displayed.
6.
If accidentally triggered before a blast, press CANCEL and go back to step 4.
7.
When finished turn unit off by pressing * for 5 seconds.
IMPORTANT : Keep unit on charge when not in use to avoid battery damage.
See User Manual for details