Introduction
- 6 -
Function
Description
Multiple traffic
modes
Energy-saving
mode
When the traffic is light, the system enters the energy-
saving mode. Based on the group control rule, fewer
elevators are running to save energy within the allowable
range of waiting time.
Up peak mode
After the system enters the up peak mode, if an elevator
has no call to respond, it returns to the peak service floor
to ease the up traffic jam on this floor.
Down peak
mode
This mode is available if zones are defined, so as to
better ease the down traffic jam. When an elevator is
idle, it returns to the terminal floor that is away from the
down peak floor in that zone. If zones are not defined,
the software automatically sets the zones.
Normal traffic
mode
When the traffic is normal and elevator calls do not differ
greatly across floors, the system works in this mode.
Sudden peak
hour mode
You can set the floors for the sudden peak hour service
and the number of elevators for these floors. If more
than three calls are received from a peak floor and no
elevator is available on the floor, the system sends the
preset number of elevators to that floor to better provide
services for the floor.
Disability
service
This function enables the system to assign an accessible elevator when
there is a call. In addition, a voice prompt is given when keys are pressed.
Real-time
guidance
After a call from a floor is received, the floor selector displays the ID of the
assigned elevator in real time.
Group control
output
Parameters can be used to view some indicators of the group control
system in a certain period of time, including the average waiting time,
average travel time, full-load rate, and long-time waiting rate.
Zoned service
Service zones are defined for elevators based on the building height and
number of floors. Zones can be defined automatically or manually.
Grouping
When multiple passengers need to take elevators at the same time to the
same floor, enter the number of passengers and the destination floor.
The system then automatically sets the number of elevators that provide
services for the passengers.
