Manual LightDriver 5.0 EN
7
13.09.2018 V2.1 | innoflyer, weissensteinstrasse 81, 4500 solothurn | www.innoflyer.ch
Layout and connection assignment
Important information:
•
Only operate Power LEDs with the Light Driver 5.0. Warning: Power LEDs
are extremely bright, do not look directly towards the light at close range
!
•
innoflyer aircraft LED lights are reverse polarity protected and cannot be
connected to the SLC incorrectly. Thanks to Plug&Play and MLT, the LEDs
are automatically supplied with the correct current. The temperature is
permanently monitored.
•
When connecting Third-Party LEDs, make sure the polarity is correct.
Do
not use series resistors.
•
The cabel length between the LEDs and the SLC can equal up to 4 m.
Always use twisted cables
(see accessories).
•
Do not operate LEDs in parallel or in a line on an SLC.
•
The receiver socket as well as the external battery connection are reverse
polarity protected. There is no possibility of energy feedback between
supply connections. Only the connection selected with the jumper is able
to supply current.
•
For programming via USB on the PC, the Light Driver 5.0 can be powered
directly via USB. If LEDs are connected to the SLC at the same time, an
additional power supply is necessary for the clean operation of the
connection.