Manual LightDriver 5.0 EN
8
13.09.2018 V2.1 | innoflyer, weissensteinstrasse 81, 4500 solothurn | www.innoflyer.ch
Start-up
Factory settings
The Light Driver 5.0 is delivered with a preconfigured setup featuring a simple 5-
channel installation. The setup is configured for operation via 3-way switches. In
order to use these, on your transmitter, programm a switch with the values pos
0: -100%, centre: 0%, pos 1: +100%
Connect your innoflyer aircraft LED lights to the Light Driver 5.0 in keeping with
the following cable assign:
SLC 1
Position light red (Wink Tip left)
SLC 2
Position light green (Wing Tip right)
SLC 3
Beacon (fuselage upper sufrace or fuselage lower
surface)
SLC 4
Tail light (rearward radiating)
SLC 5
Landing light
Via your RC system, the following on and off settings of the 5 SLCs are possible
with the 3-way switch:
Pos 0:
SLC3 on
Centre:
SLC1 + SLC2 + SLC3 + SLC4 on
Pos 1:
SLC1 to 5 on
Upon delivery, the SLCs are configured for operation with innoflyer aircraft LED
lights. If you wish to use Third-Party LEDs, the SLCs must be configured
accordingly with LightCockpit. Otherwise, the LEDs will be operated with the
minimum current of 70mA.