Manual LightDriver 5.0 EN
13
13.09.2018 V2.0 | innoflyer, weissensteinstrasse 81, 4500 solothurn | www.innoflyer.ch
General Settings
Click on the symbol to open the settings of the Light Driver 5.0.
Device Name
Give the connected Light Driver 5.0 a name.
Light Condition
Control mode
Determine how you want to switch between the 5 Light
Conditions via RC-Control. The
"Static"
variant divides
the -100% to +100% channel paths into 40% segments.
An active Light Condition is permanently assigned to each
segment. Your computer transmitter enables you to
approach these segments in a variety of ways.
The
"Dynamic"
variant enables you to call up all 5 Light
Conditions with a simple 3-way switch. Programm it as
follows:
Pos0: -100% Centre: 0% Pos1: +100%.
Toggle
Centre-Pos1-Centre
in order to move a Light
Condition up (e.g. LC1 to LC2) or toggle
Centre-Pos0-
Centre
in order to move a Light Condition down (e.g. LC5
to LC4). If you remain in Pos1 for more than 2 seconds,
Light Condition 5 will automatically become active. If you
remain in Pos0 for more than 2 seconds, Light Condition 0
will automatically become active.
Under-voltage
Alarm (UVA)
The under-voltage alarm enables you to monitor the
lighting battery. The "Under Voltage Alarm Level" enables
the continuous setting of the under voltage alarm level. An
alarm goes off (fast blinking) on the UVA, on the SLC
selected under "Under Voltage Alarm Channel". In order to
reset a UVA, you need to restart the Light Driver 5.0.
Night operation
preview
Upon activating the Night Operation Preview, all SLCs are
reduced to the Dimm Level, which is preconfigured in the
SLC Settings of each channel. This enables you to
"preview" how bright the LEDs are when Night Operation is
activated. If the Light Driver 5.0 is disconnected from the
USB, this Preview is automatically reset.
In order to activate Night Operation on land/in flight, the
Light Driver 5.0 must be connected to an RC-channel that
can be operated with a 3-way switch. Night Operation is
activated with the following sequence on the 3-way
switch:
Centre-Pos0-Centre-Pos1-Centre-Pos0-Centre-Pos1-
Centre
(Channel direction: PWM Pos0 < PWM Centre < PWM
Pos1)
Use Night Operation to prevent lighting from being
dazzling during twilight, for instance.
