Manual LightDriver 5.0 EN
15
13.09.2018 V2.0 | innoflyer, weissensteinstrasse 81, 4500 solothurn | www.innoflyer.ch
Load / Save Light Project
Click on the symbol to open the Load/Save dialog box. All the Light Cockpit
settings can be saved in a project file here. By opening one of these files, you
will call up a complete set of settings. This makes replacing a complete
configuration of the Light Driver 5.0 very easy.
Firmware Updater
Click on the symbol to open the Firmware Updater. This enables you to keep
Light Driver 5.0 up to date with new technologies. New versions of the Light
Driver 5.0 Firmware are published at
www.innoflyer.ch
. Load the Firmware file
onto your PC and open it with the "Load" button. Start the updating process by
clicking on the "Update" button and follow the instructions.
Never disconnect the Light Driver 5.0 while a Firmware update is in progress!
Expanding the system, Master-Slave operation
If your lighting project requires more than five aircraft LED lights, you can
extend the system with up to two additional Light Drivers 5.0 (max. 3x5 = 15
users).
For this, configure each Light Driver 5.0 individually with LightCockpit. It does
not matter whether they are to be used as Master or as Slave. All SLCs within a
Master-Slave system are synchronised among themselves. Connecting a Light
Driver 5.0 with the RC connection cable on the Slave 1 or Slave 2 outlet of
another Light Driver 5.0 automatically turns it into a Slave. This is visible by the
slow blinking of the State LED.
On all Slaves, "RC-Power" must be selected as a power supply (Jumper).
The Light Condition Control Mode of the Light Driver 5.0 used as a Master is valid
for the entire Master-Slave system. The Slaves are controlled by the Master. This
is regardless of how their Control Mode was configured. The same is valid for the
configuration of the standby mode.
No additional Light Drivers 5.0 can be connected to the Slave outlets of a Slave.
A Master-Slave system can significantly reduce the cabling efforts in your model
if you install Light Drivers 5.0 in each half of the wing.
