Ingersoll-Rand A951X040BD3SAB, Руководство по установке

Страница: 84 / 104

84
88-A951X001-1D-EN
1. Remove port cap on the right side of the inducer and connect
inducer condensate tubing. Connect other end of inducer
condensate tubing to top port on the condensate trap. Cut tubing
to length, if necessary.
2. Install previously removed port cap onto bottom port of the
inducer.
3. Connect condensate pressure switch tubing to pressure port on
the condensate trap.
Important: Cut to length to ensure there is no sag or trap
created.
4. Connect rain gutter condensate hose to the rain gutter and the
lower port of the condensate trap.
1
4
3
Furnace in Horizontal Right Position - Left Vented Combustion Air
Changes need to be made to the inducer orientation when installing
the upflow furnace in the horizontal right position with the combustion
air vented through the bottom. Additional changes are needed for
hose routing, condensate trap location, and inducer port caps, and the
condensate plug.
The figure to the right shows the furnace as it is sent from the factory.
Use the following steps to modify the furnace for horizontal right with
bottom venting of combustion air.
Before proceeding, lay unit on its back to make the conversion easier.
1. Remove all drain hoses from condensate trap.
Note: When removing condensate hoses from the condensate trap,
hold the trap with your hand to prevent the trap from breaking.
Removing the trap before the hoses is also an option.
2. Remove drain tubing from bottom of inducer housing.
3. Remove rain gutter tubing from inducer outlet.
4. Remove tubing from condensate pressure switch.
5. Remove the screws that hold the condensate trap bracket. The
condensate trap should not be removed from the condensate trap
bracket. Remove assembly and retain for later installation.
6. Remove the condensate adapter located inside the condensate
trap connection on the cold header and retain for later
installation.
Note: The plastic condensate adapter with O-rings located inside the
cold header that is held in place by the condensate trap
bracket. Do not lose this adapter. The condensate adapter
needs to be in place when the condensate trap bracket is
reattached.
1 6
4
3
2
5
F Fu urrn na acce e C Co om mb bu ussttiio on n A Aiirr E Ex xh ha au usstt O Op pttiio on nss