Infoblox Infoblox-4030, Инструкции по установке

Страница: 6 / 24

Copyright ©2018, Infoblox, Inc.All right reserved.
USB Ports Reserved for future use.
Power
Supplies Each of the two redundant power supplies has a power outlet for connecting the appliance to a standard DC (Direct Current) or
AC power source.
Power
Supply LEDs Green = Normal
Off = System is off or power supply has failed.
UID LED Turns blue to indicate that the appliance is currently being identified. This LED illuminates when you press the UID button on
the front panel. For information about the UID button, see
. Table 1
Ethernet Port LEDs
View the Activity and Link LEDs to see link activity and connection speeds on Ethernet ports. describes the status conveyed by Ethernet Figure 4
port LEDs through their color and illumination (steady glow or blinking).
Figure 4 Ethernet Port LEDs
10-Gigabit Ethernet Connectivity
Note: summarizes SFP/SFP+ usage for the Infoblox-4030 and Infoblox-4030-10GE appliances. Table 5
When you install the Infoblox-4030-10GE, some installation guidelines must be followed:
Install all transceivers into the ports for your appliance before turning the system on for the first time.
The LAN1 and HA ports must be set to the same line speed by using the same transceivers. In the expected 10-Gigabit deployment,
LAN1 will be set to run to 10GbE line speed. If you are running HA with a second appliance, the HA interface must be set to the same
line speed as the LAN1 port by inserting a second transceiver of the same type. This requirement applies to both RJ-45 and optical
interfaces. Otherwise, for a standalone appliance, you can leave the HA port without an installed transceiver, as the port will be inactive.
Note: If the LAN1 and HA ports have different-speed SFPs installed (LAN1=10GbE, HA=1GbE) , both ports will be set to 10GbE and the port
containing a 1GbE transceiver will not pass traffic.
The MGMT, LAN1 and LAN2 interface line speeds may be set independently.
The 10-Gigabit Ethernet option also supports mixed mode configurations, in which RJ-45 and optical transceivers may be used in the
same appliance.
Figure 5 summarizes the requirements and port order for the Infoblox-4030-10GE 10-Gigabit Ethernet configuration.
Figure 5 10GbE Port Setting Requirements