Industrial Scientific RGX Series, Руководство по эксплуатации продукта

Страница: 35 / 62

25
6 Configure options
Access Settings
RGX Gateway only
•
Review the RGX – iNet communications options: cellular, wi-fi, and
Ethernet. Enable or disable each option.
•
For each enabled option, enter, select, or edit the required values.
Reminder: If your company’s wireless network uses “WPA2 - Enterprise”
security, the RGX Interface will require the upload of a certificate of
authenticity that is 2048-bit or less and supplies the full chain of trust.
RGX Gateway operating in LENS repeater mode
Site name can be set. All other settings must be edited in iNet.
Save and Reboot
When finished, click save; the Interface will prompt you to confirm the
save.
When prompted to reboot, click on the prompt, then confirm. No other
action is needed, the software will complete the reboot.
7 Status check
Observe the LEDs* inside the case and compare them to the
"operational status" column in
Table 3.5 below.
•
The LENS Wireless status light will be off until another equipment
item joins the LENS group; otherwise, if there are no errors or
connection issues, disconnect the Ethernet cable from the unit.
•
If there are errors or issues, recheck the work completed to this
point. If an issue persists, contact Industrial Scientific.
•
Disconnect the cable from the computer and, as needed,
reconfigure the computer to the desired network.
* Note: If operating on battery power only, the interior LEDs will not be on.
8 Close case lid and secure to case base
Close the case lid and ensure all wires and cables are:
•
secure
•
contained entirely inside the case
•
away from the unit’s closure surfaces .
Reinstall the four fasteners with the T25 torx bit to secure the case lid to
the case base. Screw torque: 1.69 Nm (240 oz in)
Go to Figure 3.5 and follow the instructions to use iNet where you will
complete all other RGX settings.
Figure 3.4 Ethernet access method for RGX Configuration Interface