Indel 610535700, Руководство по оборудованию

Страница: 44 / 54

Installation Indel motion boards
Cabling
The motor cable must be laid separately from the signal and network cables. Motor cables must not
lead over clamps; if necessary, use metallic plug connectors. The shielding must be attached with all-
round contact in the pin.
Also see Indel wiring guidelines and INDEL setup guidelines.
Protective earth connection (PE)
The protective earth must be designed in accordance with EN 61800-5-1:
Cross-section of the outer conductor
[mm
2
]
Minimum cross-section of the correspon-
ding protective earth conductor S
p
[mm
2
]
S
≤
16
S
16 < S
≤
16
16
35 < S S/2
Table 6.1
Protective earth conductors that are not part of a cable must have a minimum cross-section of 4mm2.
Mains filter
The power supply must be equipped with a filter. The optimum filter and placement may need to be
defined by means of an emission measurement as the emitted interference is dependent upon the
motor cable length, among other things. Without correctly dimensioned filters, the product may cause
very frequent interference.
6.1 Cooling and ventilation
Sufficient measures must be taken to ensure that the temperature in the control cabinet does not
exceed the specified maximum. Fans or air conditioning units must therefore be placed in suitable
locations inside the control cabinet.
If air conditioning units are being used, it must be ensured that excessively low temperatures do not
cause condensation.
Page 44/54 04/11/2013; Rev 1.31
Cold air exiting the air conditioning unit must be prevented from blowing directly onto the
housing of a servo drive. In unfortunate cases, particularly where humidity is high, this can
lead to condensation on the inside of the device.