Platinum™ IP3
Installation and Operation Manual
Video Crosspoint Module (PX-576x1024-3G/PX-288x512-3G)
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 81
You can also access the
Video Crosspoint
section in the
Frame Parameters
from where you can view
status on the Active and Redundant Crosspoint in a frame, as well as set the Active Crosspoint. See
Video Crosspoint (on page 104).
LED Indicators on Video Crosspoint Module
The following system indicator LEDs are present on the front edge of the
PX-576x1024-3G (for 28 RU)
and
PX-288x512-3G (for 15 RU)
modules:
Table 29:
Module System LEDs
LED
DESCRIPTION
POWER
Power Supply indicator
Green
When lit, this indicates that 24V is enabled on this board.
ACT CTRL
Active Control
Red
Initializing
Solid Green
FPGA has configured and the Resource Module (PX-RES) is communicating with
the card
Flashing Green
Alarm condition on the card
ACT XPT
Active Crosspoint
Yellow
When lit, this indicates that this is the Active Crosspoint
Figure 26:
LEDs on the PX-576x1024-3G/PX-288x512-3G Video Crosspoint Module
Note: These LEDs are not directly visible on the Video Crosspoint when it is in normal operation since
the Front Fan module is in front of the Video Crosspoint. The
ACT XPT
(Active Crosspoint) LED on the
Front Fan module indicates which Video Crosspoint is the
Active
Crosspoint. The
ACT XPT
LED will be off
on the Front Fan module in front of the
Standby
Crosspoint.
