Platinum™ IP3
Installation and Operation Manual
AES Balanced/Coaxial Modules with TDM Capability
© 2016 Imagine Communications Corp.
Proprietary and Confidential.
September 2016 | Page 240
Controllable Parameters
Table 106:
PT-AEBT-OB/PT-AECT-OB User-Controllable Parameters List
Parameter
R/W
Description
Options
Module
Back Module Type
Reports coax or balanced back module
PT-AEBT-BMO
PT-AECT-BMO
PT-AEB-BMO
PT-AEC-BMO
Audio Reference
Selects AES reference input for source
Sync 1
Sync 2
Sync 3
Sync 4
Parameter Hysteresis
Sets hysteresis for parameters needing it
0 to 5 seconds in 500 ns
steps
Sync Select
Selects which physical sync port the module
uses as a reference
Sync1
Sync2
Sync3
Sync4
Out
Tone (1-16)
Indicates type of tone to send out AES output
Pass Input
Silence
500 Hz
1 KHz
Polarity Reversal (1-32)
R/W
Re and - to correct audio polarity in
the analog domain
Normal
Invert
Crosspoint Type
R/W
Determines crosspoint matrix requirement
TDM
Wideband
Disconnect State
R/W
Select whether to transmit AES silence or a
DC level when signal presence is lost
Silence
DC
Lock Detect (1-16)
(Table Parameter)
RO
Reports if data is re-locked by reclocking
stage
No
Yes
Phase Alarm (1-16)
(Table Parameter)
RO
Alarm set if right and left channels are out of
phase
No
Yes
Clip Detect (1-32) [RO]
(Table Parameter)
RO
Reports if signal on the input exceeds the
maximum input amplitude
Yes
No
Audio Mute (1-16)
(Table Parameter)
R/W
Sets mute for any data passing reclocking
stage
Off
On
Swap/Copy (1-16)
(Table Parameter)
R/W
Swap/Copy left and right audio channels
(NOTE: This parameter is always applied after
summing)
No Swap
Swap
Left To Right
Right to Left
Level Adjust (1-32)
(Table Parameter)
R/W
Indicates gain/attenuation applied to mono
channel
1 0dB to -30 dB in 0.5 dB
increments
