_____________________________________________________________________________________________________________________________________________________________
NetDVR User Manual
54 / 97
Figure 11.3. Preset Management Menu Figure 11.4. Patrol Management Menu
11.4
Customize Patrols
Patrols can be programmed to move the PTZ to different key points and make it stay there for a defined duration before moving on to the next point. The key points are
defined by presets which can be set by following the steps above in
Customize Presets
. To set up and call PTZ patrols:
1)
Enter the
PTZ Control
interface, shown in Figure 11.4, by selecting PTZ from the mouse menu or clicking the
PTZ
button on the front panel.
2)
Select the
Patrol
button to enter the Patrol Management menu, shown in Figure 11.5.
3)
In the
Patrol Management
menu, you may:
• Configure Patrol:
1)
Select a
Patrol Number
to set.
2)
Select valid presets (See
Customize Presets
) and click the Set button to enter the Patrol configuration menu. A sequence should have at least 2 valid presets.
3)
Set the
Key Point No.
,
Duration
, and
Speed
(Figure 11.6). The
Key Point No.
determines the order at which the PTZ will follow while cycling through the patrol.
The
Duration
refers to the time span to stay at the corresponding key point. The
Speed
defines the rate at which the PTZ will move to the current preset.
4)
Click
OK
to return to
Patrol Management
menu and repeat steps 2-3 to configure other key points.
5)
After all key points have been configured, click the defined key point No. and then click
Add
button to complete the settings.
6)
Click
OK
button to save settings and exit the current menu.
• Clear Patrol:
1)
Select a valid Patrol Number.
