_____________________________________________________________________________________________________________________________________________________________
NetDVR User Manual
53 / 97
3)
Configure the settings of baud rate, data bit, stop bit, parity, flow control, PTZ protocol and address.
4)
Click
OK
to save settings and exit the PTZ Settings menu.
Note
: All setting parameters (baud rate, data bit, stop bit, parity, flow control, PTZ protocol and address) must be consistent with the PTZ camera connected.
11.2
Understand PTZ Controls
The PTZ control panel provides a series of PTZ controls, shown in Figure 11.2. The controls on the PTZ panel include:
1)
Directional Pad/Auto-scan Buttons:
Controls the movements and directions of the PTZ. The center button is also used to start auto-scan of PTZ.
2)
Zoom:
Used to zoom in and out with the PTZ.
3)
Focus:
Used to adjust the focus of the PTZ.
4)
Iris:
Used to open up or close the iris of the PTZ.
5)
Speed:
Adjusts the movement speed of the PTZ.
6)
Light:
Turns PTZ light (if applicable) on and off.
7)
Wiper:
Turns PTZ wiper (if applicable) on and off.
8)
Zoom In:
Instantly zooms PTZ in.
9)
Center:
Centers PTZ.
11.3 Customize Presets
Presets can be set to move your PTZ camera to a desired
preset
location. To set up and call custom PTZ presets:
1)
Enter the PTZ Control interface, shown in Figure 11.3, by selecting PTZ from the mouse menu or clicking the
PTZ
button on the front panel.
2)
Select the
Preset
button to enter the Preset Management menu.
3)
In the Preset Management menu, you may:
• Configure Preset:
Use the PTZ control panel to adjust the position of the preset. Select a Preset number and click the
Set
button to save preset location.
• Clear Preset:
Select a Preset number and click the
Clear
button to delete the preset. You may also select the
Clear All
button to delete all presets.
• Call Preset:
Select a Preset and click the
Call
button.
Note:
Only valid presets can be called and deleted.
