ifm
Supplementary device manual DeviceNet interface in the AS-i ControllerE (AC1318, AC1324), Target from 15
2012-02-29
Function
The fieldbus modules
52
5.3.10
Setting "Number of channels per analogue slave"
10581
The parameter setting of the number of channels per analogue slave can be made separately for each
of the following groups. One setting always applies to the complete group. A slave-specific assignment
is not possible.
NOTE
These parameters CANNOT be seen or edited via the controller menu.
They can only be seen or edited via the DeviceNet configuration software.
This is the so-called top-down configuration.
Group
Parameter ID
Possible setting values
[Number of channels per slave]
analogue inputs of AS-i master 1
39
1 = 1 channel / slave
4 = 4 channels / slave *)
analogue outputs of AS-i master 1
43
1 = 1 channel / slave
4 = 4 channels / slave *)
analogue inputs of AS-i master 2
47
1 = 1 channel / slave
4 = 4 channels / slave *)
analogue outputs of AS-i master 2
51
1 = 1 channel / slave
4 = 4 channels / slave *)
*) preset
The following figure shows how the above-mentioned parameters are displayed.
Example: DeviceNet configuration software RSNetWorx for DeviceNet
