Part 3 - Configuration
52
Use the remote control's arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the
Camera
buttons.
You can use the mouse to drag the zone and then
select, clear, or reverse the selection.
From the zone selection screen, press the
"
button
or right-click on the mouse to open up the Zone Setup
menu.
-
Select
: Confirm the block selection in the
selection window.
-
Clear
: Clear the block selection in the selection
window.
-
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
-
Select All
: Select all blocks.
-
Clear All
: Clear all block selections.
-
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
-
OK
: Save the changes and exit the menu.
-
Cancel
: Exit the menu without saving the
changes.
•
Min. Blocks
: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone
for daytime and nighttime, each.
•
Actions
: Specify which actions to take when
motion is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels and beeps.
-
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
In order to use the Callback feature, the NVR must
be registered on the remote program.
•
Motion Ignoring Time
: The system does not
produce event log entries or issues remote
notifications regarding motion detected during the
specified time following the initial motion detection.
Set a value between 1 sec and 5 secs or choose
Never.
Motion Ignoring Time does not affect motion
detection recording.
•
Daytime Setup
: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
