Mounting
1.
Pull the cable through the cable hole in the
back panel
, leaving 15-20cm excess cable length.
2.
With the L-shaped hex tool provided, remove the four security screws and lift the front plate out of the
enclosure.
3.
Using the 4 TA5 40mm screws, mount the
back panel
to the wall.
Note
: the intercom is equipped with a secondary cable hole at the bottom of the back panel.
Connect and Test
1.
Connect to the intercom board connectors:
-
RJ45
-
Power
-
Electric-Lock
2.
Refer to the
Connections
page (see page 9).
3.
To test, press the # key on the
circuit board
for 3 seconds to obtain the IP address of the intercom unit.
Do Not proceed until the electric checks are confirmed.
Completion
1.
Attach the
intercom
and
rain shade
to the
back panel
.
2.
Push the
front panel
carefully into the plastic frame and replace the 6 screws, ensuring the screws have
been tightened correctly and the panels are secure to ensure waterproofing.
PRT-IPIC-POE-C | Vandal Resistant VoIP Intercom with Camera | Installation Manual
13
