Mounting
Pull the cable through the cable hole in the
back panel
, leaving 15-20cm excess cable length.
Using the 4 PA4 60mm screws, mount the
back panel
inside the wall cavity,
Note
: the intercom is equipped with a secondary cable hole at the bottom of the back panel.
Connect and Test
1.
Connect to the intercom board connectors:
-
RJ45
-
Power
-
Electric-Lock
2.
Refer to the
Connections
page (see page 9).
3.
To test, press the # key on the
circuit board
for 3 seconds to obtain the IP address of the intercom unit.
Do Not proceed until the electric checks are confirmed.
Completion
1.
Attach the
intercom
to the
back panel
.
2.
Using 4 PA4*60mm screws, attach the intercom into the wall cavity and seal the gap between the frame
panel and the wall surface.
3.
Push the
front panel
carefully into the plastic frame, ensuring the security screws have been tightened
correctly and the panels are secure to ensure waterproofing.
PRT-IPIC-POE-C | Vandal Resistant VoIP Intercom with Camera | Installation Manual
16
