162
14
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
User Band Edge
7.
This “User Band Edge” item appears only when “ON
(User)” or “User (ON) & TX” is selected in the “Band
Edge Beep” item. (p. 161)
When you select “ON (User)” or “ON (User) & TX” in
the “Band Edge Beep” item, you can program a total
of 30 band edge frequencies in this item. See page 42
for programming details.
Beep Sound (MAIN)
8.
(Default: 1000Hz)
Set a desired beep frequency for the MAIN Band to
between 500 Hz and 2000 Hz in 10 Hz steps.
You can set the beep output level in
the “Beep Level”
item. (p. 161)
Beep Sound (SUB)
9.
(Default: 1000Hz)
Set a desired beep frequency for the SUB Band to be-
tween 500 Hz and 2000 Hz in 10 Hz steps.
You can set the beep output level in
the “Beep Level”
item. (p. 161)
RF/SQL Control
10.
(Default: RF+SQL)
Set the [RF/SQL] control operation.
• AUTO
: [RF/SQL] functions as only an RF
gain control in SSB, CW and RTTY; a
squelch control in AM, FM and DV.
• SQL
: [RF/SQL] function
s as a squelch con-
trol.
• RF+SQL : [RF/SQL] function
s as a noise squelch
or an
S-meter squelch in FM; only
as
an S-meter squelch in SSB, CW,
RTTY
,
AM and DV.
Meter Peak Hold
11.
(Default: ON)
Turn the Meter Peak Hold function ON or OFF.
When this function is set to ON, the peak level of a re-
ceived signal strength or the output power is displayed
for approximately 0.5 seconds.
FM/DV Center Error
12.
(Default: ON)
Turn the FM and DV center error detection ON or
OFF.
When an off-frequency signal is received, the MAIN
and SUB Band’s TX/RX indicators blink.
Time Out Timer
13.
(Default: OFF)
To prevent a prolonged transmission, the transceiver
has a Time-Out Timer function.
If a continuous transmission exceeds the set period,
the transmission will be cut off.
Set the time period to 3, 5, 10, 20 or 30 minutes, or
turn OFF the Time-Out Timer function.
PTT Lock
14.
(Default: OFF)
Turn the PTT Lock function ON or OFF.
To prevent accidental transmissions, this function in-
hibits transmitting, when turned ON.
Quick SPLIT
15.
(Default: ON)
Turn the Quick Split function ON or OFF.
When this item is set to ON, hold down [SPLIT] for 1
second to shift the transmit frequency from the receive
frequency, according to the “SPLIT Offset” option as
described below. See page 83 for details.
SPLIT Offset
16.
(Default: 0.000MHz)
Set the offset* for the quick split function.
*The difference between transmit and receive frequencies.
The frequency offset can be set to between –9.999
MHz and +9.999 MHz in 1 kHz steps.
SPLIT LOCK
17.
(Default: OFF)
Turn the Split Lock function ON or OFF.
When this item is set to ON, you can use [MAIN DIAL]
to adjust the transmit frequency while holding down
[XFC], even while the Dial Lock function is enabled.
See pages 82, 83 for split frequency operation de-
tails.
