IBM ZVM - FOR LINUX V6 RELEASE 1, Начало работы

Страница: 125 / 172

If you want to ... Then use this command ...
Link to another disk
(read-only mode) LINK userid vdev1 vdev2 RR
vdev1 is userid ’s virtual address; vdev2 is an available virtual
address in your virtual machine configuration.
Examples:
%cp link linux01 150 150 rr
If you use “vmcp” to address CP:
vmcp link linux01 150 150 rr
Load (boot) Linux in a
virtual machine IPL
IPL (initial program load) and boot are synonymous.
Examples:
%cp ipl 150 clear
If you use “vmcp” to address CP:
vmcp ipl 150 clear
Make CP display the
HOLDING status when
the display screen is full
and highlighted output
appears on the screen. TERMINAL HOLD ON
When the display screen is in HOLDING status and you want to
clear the display, press the PA1 or CLEAR key.
Examples:
%cp terminal hold on
If you use “vmcp” to address CP:
vmcp terminal hold on
Change the number of
seconds that elapse
between the time when
CP issues the MORE...
state and sounds the
terminal alarm, and
between the time when
CP sounds the alarm and
clears the display. TERMINAL MORE mm nn
Examples:
%cp terminal more 5 2
If you use “vmcp” to address CP:
vmcp terminal more 5 2
means CP waits 5 seconds after issuing the MORE... state before
sounding the terminal alarm, then 2 seconds after sounding the
alarm before clearing the display.
You are done.
Chapter 10. Performing run-time tasks
111