IBM System Storage TS2900, Руководство по установке, эксплуатации и обслуживанию

Страница: 196 / 257

B-4
TS2900 Tape Autoloader Setup, Operator, and Service Guide
005D
I
2
C I/F error.
Invalid signal (NAK)
detected. Suspect the bar
code reader cable connection.
CHK 005D
1. Initiate an inventory. See “Conducting a Library
Inventory” on page 4-6 (Operator Panel) or
“Conducting a Library Inventory” on page 4-19
(Web User Interface).
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
005E
I
2
C I/F error.
Bus arbitration lost error
detected. Suspect the bar
code reader cable connection.
CHK 005E
005F
I
2
C I/F error.
Ready condition does not
occur. Suspect the bar code
reader cable connection.
CHK 005F
0070
Calibration failed because the
Accessor contains media.
Suspect the centering sensor.
CHK 0070
1.
Attempt to unload the cartridge from the
Accessor. See “Moving Cartridges” on page 4-5
(Operator Panel) or “Moving Cartridges” on
page 4-17 (Web User Interface).
2.
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0071
Calibration failed due to an
empty magazine. Suspect the
magazine set sensor.
CHK 0071
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0072
Calibration measurement
invalid data error. Suspect
the centering sensor, X motor,
or P motor.
CHK 0072
0074
GET, centering check, or bar
code reader read operation
failed because the Accessor
contains media. Suspect the
centering sensor.
CHK 0074
0075
PUT operation failed because
the Accessor contains no
media. Suspect the centering
sensor.
CHK 0075
007C
Drive does not enter EJECT
state (and media not ejected)
within 200 seconds of a GET
command. Suspect the drive.
CHK 007C
1. If the cartridge does not eject, try to unload the
cartridge from the drive using the Operator
Panel (
Commands
→
Unload ) or the Web User
Interface (
Manage Library
→
Unload
). Move
the cartridge from the drive to the I/O Station.
Remove the cartridge from the library and
inspect for damage and replace, if necessary.
2.
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
Table B-1. Library error codes (continued)
Code (H) Description Panel Indication Action Required